Industrial Fan Manufacturing · Zibo, China
QIYUE FAN industrial fan manufacturer
Menu

QIYUE FAN / CERAMICS PRODUCTION

Ceramic Factory Extraction Fans: Dry Fettling and Glaze Mist Are Different Duties

A request for a “ceramic dust fan” can describe two very different air streams: dry material removed from unfired ware, or mist from a glaze-spraying booth. Identify the process and separation equipment before comparing fan quotations. Workshop floor area alone does not define either duty.

Two process questions before fan selection

Dry fettling

Dried, unfired ware → dust generated at the workpieceDefine the extracted enclosure and dust collectorSpecify residual solids and resistance at the fan

Glaze spraying

Spraying → mist, overspray and drying depositsDefine the booth and mist/overspray separationSpecify moisture, chemistry and carryover at the fan

Process-selection schematic. Equipment arrangement is defined by the project design.

Dry fettling: start at the workpiece

HSE’s CR3 guidance concerns trimming dried, unfired cast items. It does not cover wet fettling or grinding and polishing fired ware. The distinction matters when describing the material and task to a ventilation designer.

CR3 calls for local extraction at an enclosure that accommodates the work properly, with the task carried out inside it. It also addresses interfering draughts, replacement air and a means of checking extraction performance. Record the enclosure opening, workpiece size and operating positions rather than specifying an arbitrary air-change rate.

For the fan enquiry, identify particle loading and abrasion exposure before and after the collector. Use the dust-collection system selection page to organise collector resistance and fan position. A dedicated dust-handling label is not, by itself, proof that a fan is suitable for the actual mineral dust.

Glaze spraying: wet operation can still create dust

HSE’s CR5 guidance explains that glaze spraying can generate silica-containing mist and that drying deposits can become airborne dust. Other hazardous glaze constituents also need assessment. Provide the glaze safety data and actual booth arrangement, not just the description “water-based”.

CR5 discusses an extracted enclosure and, where possible, water-backed overspray capture. For fan selection, establish what remains in the air after that separation stage. Ask the booth supplier for the operating airflow, resistance and expected carryover; include moisture and chemical composition when reviewing construction materials.

Do not choose stainless steel or FRP solely from the fact that the process is wet. Compare the actual medium, concentration and temperature with the corrosion-resistant construction options. Confirm access for inspection and cleaning with the equipment layout.

Define the fan package and the system acceptance separately

The fan quotation should identify the agreed airflow and pressure basis, gas condition, construction, drive, electrical supply and mechanical interfaces. A collector or booth quotation should identify its separation and resistance conditions. This keeps two suppliers from pricing different operating cases under the same project name.

Respirable crystalline silica exposure requires competent control-system assessment. Extraction performance and workplace protection must be verified as a system, not inferred from a motor rating. HSE’s process guidance also addresses airflow indication, safe discharge and monitoring where cleaned air is recirculated.

For a replacement, send the fan and motor nameplates, booth or collector details, and a photograph of the connected duct route. State whether the problem is weak capture, deposits, wear or a process change. These observations help distinguish a fan-selection issue from a capture or separation issue.

Technical references: HSE CR3: Dry fettling and CR5: Spraying glazes and colours. These process-specific documents should be read alongside the project’s ventilation and exposure-control assessment.