QIYUE FAN · STONE WORKSHOP EXTRACTION
Slate Saw Dust Extraction: Specify Both Capture Points Before Replacing the Fan
A slate saw can release dust above and below its working table. A replacement fan quotation is more useful when it starts with the machine enclosure and both extraction connections, rather than the old motor rating alone.
Slate dust can contain respirable crystalline silica. Source control, exposure assessment and suitable protection remain part of the complete workplace control system; a fan purchase alone does not establish safe exposure.
Two capture points, one coordinated duty
Above the table
Identify the crown-guard extraction connection and its required airflow. Record how the guard follows the workpiece and which openings remain during cutting.
Below the table
Show the under-bench enclosure and its separate extraction branch. Include access openings and the branch connection, so the lower capture point is not lost from the quotation.
HSE’s slate-sawing guidance calls for enclosure and extraction at the crown guard and beneath the bench. It also highlights replacement air, discharge location and a visible indication that extraction is working. See HSE ST5: Sawing slate.
↓
Specified branch network and dust collection
↓
Fan duty at its actual installation position
Conceptual procurement route. Equipment order, connections and controls follow the project designer’s approved layout.
Make the two branches visible in the quotation
Provide a marked machine drawing with each extract port labelled. For each branch, record the machine supplier’s required airflow, connection dimensions, duct route and the operating condition in which the value applies. Identify which machines run together. The fan duty must cover that agreed combination, not simply add every nameplate capacity in the workshop.
Separate branch losses from common-duct and collector losses. Where a collector specification already includes a connection or filter section, mark that boundary once. This lets competing fan offers use the same pressure basis instead of quietly including different equipment.
Wet processing is a different equipment review
Do not transfer a dry slate extraction specification to water-suppressed stone processing. Record moisture, slurry or droplet carryover and the fan position before selecting exposed materials or collection equipment. HSE distinguishes slate sawing under extraction from primary and secondary stone sawing using water suppression.
Portable on-tool extraction for installation work is also a different system from a central industrial fan. HSE’s stone-worktop guidance addresses water suppression, suitable on-tool collection and cleanup; a larger room fan is not a substitute for those controls.
Start with the existing installation
For a replacement enquiry, send the fan and motor nameplates, machine and collector models, both capture-point drawings, branch airflow records, fan inlet conditions and available installation dimensions. Explain whether the problem occurs at the upper guard, below the bench or across several machines. That distinction helps separate a local capture problem from a common fan-duty issue.
Review the industrial dust-collection system and dust-collection fan range alongside the machine supplier’s requirements. Model suitability, abrasion and moisture limits must be confirmed for the actual fan inlet; no model is selected solely from the word “stone”.
Discuss a slate-workshop fan replacement
Share the machine layout, extraction branches and existing fan data for a duty-based review.
Send the project information →