QIYUE FAN / SURFACE PREPARATION DUST EXTRACTION
Blast Room Dust Extraction Fan Selection: Separate Ventilation from Abrasive Recovery
For a blasting room or cabinet, the exhaust fan belongs to the dust-control system. Its duty is different from the air used to propel abrasive and from equipment that recovers reusable blasting media.
Identify the machine and the material being removed
State whether the project uses a manual blast room, a cabinet or an automated machine, and whether the process is dry or wet. Include the abrasive specification, workpiece material and coatings being removed. OSHA and CCOHS identify both the abrasive and the treated surface as relevant sources of dust hazards. “Steel shot” or “sandblasting” alone is not a complete description of the extracted medium.
For a quotation, attach the machine layout, working openings, operating schedule and the extraction duty supplied by its designer. Keep compressed-air consumption at a blasting nozzle separate from the exhaust-air requirement.
Keep extraction and abrasive recovery as separate duties
Ventilation removes dust-laden enclosure air. A recovery system handles used media, and a separator distinguishes reusable abrasive from fines or other unwanted material. OSHA’s US blasting provisions specifically distinguish enclosure exhaust from the abrasive separator in recirculating installations.
Ask the equipment supplier to identify the flow and pressure required at each extraction connection, including any separately extracted recovery equipment. Record which branches operate together. This makes it possible to compare a fan-only quotation with the actual system scope instead of assuming one room-exhaust rating covers every connected function.
Establish the collector and fan interface
Obtain the collector’s specified operating resistance, flow basis and connection details. Combine these with the enclosure, duct and discharge requirements using a consistent pressure definition. If the fan is downstream of the collector, specify the expected gas and residual particulate conditions at that location. Do not use the raw blasting-media feed rate as the fan-inlet dust loading.
The fan proposal should identify operating speed, duty point, power and construction for the agreed inlet conditions. If wear protection or access for inspection is proposed, include its scope and effect on the assembly drawing rather than relying on a generic “heavy-duty” description.
Agree the acceptance checks before ordering
The enclosure design must address inward airflow at openings and dust clearance as well as the fan’s aerodynamic duty. Ask the responsible specialist to define the commissioning measurements, clearance procedure and control sequence for the actual equipment. OSHA’s blasting provisions also address exhaust pressure-drop checks and dust collection.
Dust composition, combustible-dust risk and worker protection belong in the project risk assessment. A dust collector or fan alone does not establish safe exposure conditions. Keep those specialist requirements in the purchase specification without substituting a universal airflow, motor size or clearance time.
Prepare the blasting-extraction brief
- Machine: room or cabinet layout, process type, openings and simultaneous operating branches.
- Material: abrasive data, substrate/coatings, dust characteristics and relevant risk-assessment requirements.
- Duty: designer’s extraction flows, pressure schedule, collector resistance and fan location.
- Package: fan, motor, connections, supports, controls, wear/access provisions and documentation.
- Acceptance: fan performance basis, system measurements and the responsible commissioning party.
Continue with the dust collection system guide and collector fan selection guide. Send the defined extraction duty for a QIYUE FAN review.
Send Your Blasting-Extraction Enquiry → Include the defined extraction duty, collector details and available machine drawings.
References: OSHA 1910.94(a): abrasive blasting ventilation; OSHA: abrasive blasting materials; CCOHS: abrasive blasting. Apply the requirements relevant to the project location and process.
